rayz
2012-09-21 22:54:45
- #1
Hello,
I am trying to equip a Faktum base cabinet with 5 drawers. At the bottom one with an 18 cm panel, the other 4 panels just under 13 cm. The problem is that only the first two drawers from the bottom can be installed. The spacing for the third one is not correct. You can only compensate for this by rotating the panel. But then the same problem occurs with the next drawer. I am considering adding a row of additional holes because the spacing of the existing hole pattern does not fit. But there is little space and it has to be quite precise. The holes should not go too deep either, as one side is openly visible.
Is there perhaps an extra drawer set for this cabinet? It is quite strange that the back edge of the drawer is almost the same height as the front panel.
Does anyone have experience with this? I would be very grateful for help!
Regards
Jens
I am trying to equip a Faktum base cabinet with 5 drawers. At the bottom one with an 18 cm panel, the other 4 panels just under 13 cm. The problem is that only the first two drawers from the bottom can be installed. The spacing for the third one is not correct. You can only compensate for this by rotating the panel. But then the same problem occurs with the next drawer. I am considering adding a row of additional holes because the spacing of the existing hole pattern does not fit. But there is little space and it has to be quite precise. The holes should not go too deep either, as one side is openly visible.
Is there perhaps an extra drawer set for this cabinet? It is quite strange that the back edge of the drawer is almost the same height as the front panel.
Does anyone have experience with this? I would be very grateful for help!
Regards
Jens