Setting gas condensing boiler Junkers Cerapurmodul ZBS 14

The button at the top left is indeed Auto.

Just checked, for your controller it’s enough to remove the setback, then it will be in automatic mode. The underfloor heating mode is off, then you have to experiment with the foot-/end point.

Look at the actual flow temperature the heating receives. Besides the high storage temperature, the cycling can also be caused by this. How much hysteresis do you give the hot water storage tank before reheating occurs?

Look at what actual supply temperature the heating system receives. Besides the high storage temperature, the cycling can also be caused by this. How much hysteresis do you give the hot water storage tank before reheating?

Where can I find both pieces of information?

Where can I find the two pieces of information?

There should actually be thermometers on the supply and return pipes.

There should actually be thermometers on the supply and return pipes.

There are no thermometers on the pipes (see pictures).

I once set the temperature when heating from 19.5 to 20.5 and adjusted the heating curve at the endpoint from 44 to 42 and at the base point from 27 to 24.

Furthermore, I set the heating times back to 4:00 - 20:00. After I set it to continuous operation on Monday evening, the heating increased from about 100 cycles/day to 200.

I stood next to the heating for a few minutes just now and it switches on and after about 10 seconds it switches off again, so completely pointless.

The last picture with the pump post-run time, is 6 minutes okay?

Thank you so much!