Inner drawer driver

Great, thanks. The 25 mm bore presents a problem for many, for whatever reason. How is the part attached to the inner drawer?

So far only plugged in. I have removed 1.8mm with the router, resulting in a slight oversize fit. The red things are still the release films from a adhesive tape, so I assume that they are normally just stuck on. I think I will fix it with a screw from behind.

Just for completeness. Instead of Utrusta, the Blum aluminum front Z31L1036A (white) (€15.20) with the side plastic holders ZIF.71M0 (white) (€4.70) should fit. If that works, then the ZIF.80M7 (white) handle with driver (€6.62) can be installed.

However, simply shortening the aluminum fronts is certainly more complicated than what has been proposed so far.

The parts are for height M, Maximera frames are rather height N. There is nothing for that.

Ok, then I said nothing

Couldn't 3 strong magnet pairs embedded into the wood, which was previously hollowed out, achieve the same? Just a tip.