Ikea Besta shelf and Ikea Inreda drawer with full extension

Hello,

I have a Bestå shelf 120 cm wide, 38 cm high and 40 cm deep. The shelf therefore consists of two compartments 60 cm wide each. On the left and right, I have installed an Inreda drawer 16 cm high with full extension and Tofta front. The slots of the front face downward. The two drawers also close flush with the bottom edge of the shelf. So far, everything is still okay. Above the two drawers, the shelf board should be installed as a finish. For this, I used the metal brackets that come with the drawers so that the shelf board ends flush with the front edge of the drawer fronts. That also fits.

BUT the drawer now rubs against the underside of the shelf board!

As described above, everything looks good in terms of distances, front, etc. If I place the metal brackets one hole higher, the shelf board is too high. The bottom edge of the shelf board then protrudes above the drawer front. I hope I have described everything clearly. Does anyone have any other ideas or has already had this experience?

Does it rub over the entire depth of the drawer? If it is only in the front area, then check if the height adjustment is screwed in all the way. Without seeing it, the only other quick idea that comes to mind is to raise the front a bit and see how it looks and fits if the lower cabinet edge is not covered by the front.

Hello everyone,
I am new here because I bought a Besta TV stand yesterday and now have the same problem as described above. Is there already a solution for this?
Thanks to you