1979m
2018-08-08 20:44:33
- #1
In the 36 cm masonry, only about 20 cm of adhesive was applied. This results in open joints of up to 12 cm both inside and outside.
In the Ytong instructions, I always find that the adhesive must be applied over the entire surface and not just on 20 out of 36 cm.
What disadvantages can I expect with such an execution?
Is this a defect and can it be remedied?

In the Ytong instructions, I always find that the adhesive must be applied over the entire surface and not just on 20 out of 36 cm.
What disadvantages can I expect with such an execution?
Is this a defect and can it be remedied?