4sgr
2012-09-08 23:16:09
- #1
Hello everyone,
today we successfully assembled a Pax Hasvik. The closet stands in water, the sliding doors as well.
Only the appearance is not quite as it should be. The sliding doors run well, but the top one fits perfectly at the bottom, at the top it sticks about half a cm further towards the center. For the lower sliding door, everything is perfect at the top, but at the bottom it sticks more than one cm inward. As if the doors were twisted. If you lift the lower door at the bottom outside with your finger, then it fits, can this possibly also be achieved with a screw or a trick?
Thanks
today we successfully assembled a Pax Hasvik. The closet stands in water, the sliding doors as well.
Only the appearance is not quite as it should be. The sliding doors run well, but the top one fits perfectly at the bottom, at the top it sticks about half a cm further towards the center. For the lower sliding door, everything is perfect at the top, but at the bottom it sticks more than one cm inward. As if the doors were twisted. If you lift the lower door at the bottom outside with your finger, then it fits, can this possibly also be achieved with a screw or a trick?
Thanks