Install Ikea Utrusta lift hinge in Faktum cabinet

Hello everyone,

I have a Faktum kitchen, in which (once again) a lift hinge on a Faktum wall cabinet has broken. The Ikea service kindly sent me these hinges:



Unfortunately, the Faktum cabinet does not have the corresponding holes for the hinges.

However, it has the small Utrusta hinge. Does anyone know the spacing for the holes for the large hinge?

Thanks and regards,
Jonas

Simply 5 cm lower than with the small flap hinge.

Ah ok, so 52 mm from the front and 100 mm from the outer top edge? Is the rear hole also 100 mm from the top?

The holes for the screws are located somewhere. There are only two positions for the two nipples.

Page 6, first and second picture. There you can also clearly see the 50 mm distances.

Strange, with my hinges there is only the upper nipple and the other one lies horizontally further back (apparently at the same height). They must have sent me a prototype. I think I will now buy the smaller version after all, because these are too big for the cabinet. Besides, they seem to be some other variant than the ones currently available. In any case, thank you very much for the support!

These are from the FAKTUM cabinet.