IKEA PAX sliding doors Uggdal, error during door installation

Hello, we are totally frustrated, have almost managed to assemble 2 x Ikea Pax 75 with sliding doors. But when hanging the back sliding door, it keeps falling towards us, even though we hang it first at the bottom, then at the top. Help, what are we doing wrong?

Hello,
I have the same problem with the sliding doors TONNES. Can someone please help me?

Thank you in advance

best regards
Castor

Yes, I feel the same way, could it be due to a slight tilt of the cabinets? For me, I can easily hang the back door, but when I move it, for example to the right, it pops out of the track again. Why does Ikea also make the track 2mm high? If it were deeper, it might work. Does anyone perhaps have a solution for the problem?

I know now what the problem is. For me, the right roller could not sit properly in the track because this gray plastic safety part, which you are supposed to tilt during installation, was in the way. That means you have to fold it away correctly and then hook it in, and it's best to check from above whether the wheel is properly in the track. Best done with two people, meaning one holds, the other watches.
I hope this helps you.

Hi,
thanks to you. In the meantime, I had already figured that out. We also have the problem that the grey fuse does not run under the rail but in front of the rail. I then folded the fuse away, moved the sliding door a little, and then the door properly locked into place. Then you can re-engage the latch (this time the fuse is under the rail) and lo and behold: the sliding door can be moved without it slipping out of the rail.

Thank you very much for the help and I hope that my problem solution will also help others.

Regards
Castor