How to remove Haro parquet (Top Connect)?

Hello everyone,

since I am not satisfied with the installation of our floating Haro prefinished parquet (it creaks terribly, especially in winter when the heating is on), I want to remove it and troubleshoot, and possibly glue it afterwards. However, I am having trouble removing the parquet. It is the Top Connect variant where the end side "locks" once joined. I couldn’t find any instructions on how to undo this without damage, and I can’t figure it out myself. Does anyone perhaps have a tip?

Thank you very much in advance. I look forward to any ideas!

Found this here on the Google search… (Status at the end of the installation instructions)

Thank you, yes I had also found that with Haro. Unfortunately, that does not explain how to remove a once installed parquet of this type again without damage. Sliding it apart in parallel is then no longer possible...

I suspect you have to fold up the entire row at once (for long sections, preferably with two people). Then slide apart the individual boards of this row.

That's a good idea! I didn't think of that at all. Although it will be tough in practice, since the room is quite large...

I guess you have to fold up the entire row at once (for long distances best with two people). Then slide apart the individual boards of this row.

Correct. That works.

Although that gets intense in practice, since the room is quite large...

It's not a problem. It goes out smoothly with Haro.