How to lift drywall sheets?

Hello dear forum,

one more question about the technique:

See sketch ... under the middle purlin, gypsum boards are now to be installed over the vapor barrier, and since we have already set the profiles for this, we see that a panel lifter (borrowed from OBI) can only work from a height of 150cm.

So how do I – and this is a question of technique – lift the panels with 2 people in such a way that they finish flush with the knee wall at the back and under the middle purlin. It should fit properly ...

Last night that was quite a demanding task – isn't there any professional tip for that?

Hello,

do you want to set the knee wall later? Then I don't understand your problem right now, because then you could let the boards go through at the bottom and you don't have to pay attention to the millimeter exactly. Later then the construction of the knee wall in front and you have a clean finish at the bottom.

Yeah, the answer is in your response ... I can do the dremel first and then place the board on.

I was just concerned about the heavy lifting itself - the plates are really heavy ... thanks