Handles, template, distances, symmetry - despair

Hello everyone... I can't decide how to install the handles... I have the template, but...

Some drawers are 10, 20, or 40...

I would like to lay the template horizontally and then use the bottom holes, but then it doesn't fit on the 10cm drawers...
I took extra wide handles...

Somehow I'm having a mental block right now...

Which grips are they then?

Oh Sorry:

VARNHEM
Handle, steel-colored

Varnhem 41cm

So far, I have done it like this: For the narrow drawer in the middle and for the others with the same distance from the top. You can also first stick a few strips with, for example, insulating tape and see how the positions appear.

That's the supposed problem. Somehow, I find the handles too high when I take the middle of a 10er. Especially the top ones are somehow harder to grip then.

But it might also just be a feeling, because a wrong decision would leave a HOLE in the nice red glossy front... aaahhhhhhh I can't decide...

If I take the IKEA catalog pictures as an example, I see that in my configuration the following applies...
10er in the middle, 20er and 40er lower....
Hm

In the catalog, you can hardly see drawers that are 10 cm high. On pp. 10/11, the handles are even mounted above the middle, namely like on the higher fronts with frames – in the middle of the frame. Pp. 22/23: the distance from the top goes into the 40-front 8 times, thus approx. 5 cm = half the height of a narrow drawer front.