Dirk411
2015-03-13 11:17:42
- #1
Hello everyone, I have three questions:
For our new building, we have planned the following insulation for the floor (from top to bottom):
6 cm cement screed
3 cm Rollfix PST WLG 045
3 cm Jackodur KF300 WLG 035
PE moisture barrier
4 cm Jackodur KF300 WLG 035
I would like to know at what point I should install the edge strips? If I remember correctly from our screed installer, he said only after the two layers of Jackodur...
A friend of mine said the same...
But on the internet, I only find descriptions where the edge strips are applied directly before the first layer of Jackodur or styrofoam!?
One question about the moisture barrier... Is it simply laid flush against the wall, or even "glued up" the wall?
And one more question about the "transitions" when we come from the room into the hallway, for example, do I simply cut out a piece from the panel and then lay it around the door? (You understand what I mean)
Thanks in advance for the answers!
For our new building, we have planned the following insulation for the floor (from top to bottom):
6 cm cement screed
3 cm Rollfix PST WLG 045
3 cm Jackodur KF300 WLG 035
PE moisture barrier
4 cm Jackodur KF300 WLG 035
I would like to know at what point I should install the edge strips? If I remember correctly from our screed installer, he said only after the two layers of Jackodur...
A friend of mine said the same...
But on the internet, I only find descriptions where the edge strips are applied directly before the first layer of Jackodur or styrofoam!?
One question about the moisture barrier... Is it simply laid flush against the wall, or even "glued up" the wall?
And one more question about the "transitions" when we come from the room into the hallway, for example, do I simply cut out a piece from the panel and then lay it around the door? (You understand what I mean)
Thanks in advance for the answers!