Andreas69
2024-03-24 11:59:19
- #1
Hello,
while chiseling/drilling the opening of a floor socket, I hit the pipe of the underfloor heating. Luckily, I did not puncture or drill into the pipe but only made a dent about 1mm deep with the hammer drill. No water is leaking, and the heating is currently cold. It is a low-temperature system (heat pump), and the installed pipe is a multilayer composite pipe made of PE. My installer will take a look at it the day after tomorrow, but I would like to have a "second opinion" before I have to chisel the floor further or just leave it as it is.
Best regards
Andreas
while chiseling/drilling the opening of a floor socket, I hit the pipe of the underfloor heating. Luckily, I did not puncture or drill into the pipe but only made a dent about 1mm deep with the hammer drill. No water is leaking, and the heating is currently cold. It is a low-temperature system (heat pump), and the installed pipe is a multilayer composite pipe made of PE. My installer will take a look at it the day after tomorrow, but I would like to have a "second opinion" before I have to chisel the floor further or just leave it as it is.
Best regards
Andreas