Build a partition wall for the workshop using OSB boards

Hello everyone,

I want to partition off a workshop in an old agricultural barn. The workshop will be approximately 4m x 8m in size with a ceiling height of 3m. I recently poured the floor slab, and now the partition wall to the rest of the barn is next. Basically, I would build the partition wall with OSB boards and insulate in between so that I can also heat the room.

Since I have little experience in this area, I hope for your support. Are OSB3 boards in 15mm sufficient here (both sides will be boarded)? Which insulation and beam thickness can you recommend? What beam spacing should be used with which boards?

Thanks in advance and best regards

Tom

So OSB boards are available in 62.5cm; 125cm; 250cm. It follows: average beam spacing 62.5cm. Insulation felt in 62.5cm or wood fiber is available in 57.5cm. It follows: beam width 6cm (insulation felt can be compressed that much). Depth of the beams depending on the requirement.