Baseboard at floor level difference

Thank you for the feedback!

Make the baseboard in the higher room a bit narrower so that there is a uniform line above the board.

By making it narrower, I assume it means shortening the length of the board downwards. Then I would have to shorten all the boards in the higher room like that...

simply notch out the bottom so that it runs at the same height at the top

What is meant by notch out? The boards are attached with adhesive.

Ah, I think I understand what is meant. But it would be like above: shorten all the boards in the higher room...

Regards

Omit a few centimeters of skirting board in the area of the dark floor and apply an MS polymer joint there. Since the material cures virtually without shrinkage and remains permanently elastic, such wide joints are possible without cracking.

Thanks for the feedback!



By making it narrower, I assume it means shortening the strip lengthwise downwards. Then I would have to shorten all the strips in the higher room accordingly...



What is meant by notching? The strips are attached with adhesive.

Ah, I think I understand what is meant. But it would be as above: shorten all the strips in the higher room...

Best regards

That's exactly how I would do it; I think it looks the neatest.

We had the choice between two heights for the baseboards (approx. 4 cm or approx. 6 cm). If the larger room is higher, I would install 4 cm baseboards there and shorten the 6 cm baseboards accordingly in height in the lower room (provided the noticeable shortening is not too apparent).

Is this a new building? Why is the floor not on one level? You keep bumping into the edge from one side.

Is this a new building? Why isn’t the floor level? You keep running into the edge from one side.

An old building. We are renovating right now. Unfortunately, almost all rooms have different floor levels. Removing the entire screed and laying a new one was not possible. So we have to live with the small steps.

I have now found a solution for my problem. Please don’t laugh, I am an amateur. But it works for us now.

I cut a template and trimmed the baseboard at the bottom at an angle.