Assembly of Ikea Faktum tall cabinet with oven does not work

Hello,

during the installation of our kitchen, we have the following problem: The upper door and the panel above the oven of the cabinet are so close together after inserting the oven that they rub against each other. And on the lower cabinet door, a metal lip (on the underside of the oven) is rubbing. Somehow it seems as if the cabinet body is 2 cm too short. We have fully adjusted the hinges, yet it still does not fit properly. Are we doing something wrong? Unfortunately, the instructions provide very little information.

Best regards erhtbbeehre

In step 7 selected the correct carriers?

yes, we have that

Good evening,
did you cut the blind (9.4 cm) according to the instructions?

Regards
Gismospapa

The panel is already 9.4 cm. Does anyone else have an idea? We have now adjusted via the feet, but the upper cabinet door is not straight and rubs on the right side of the panel when closing. We have exhausted the adjustment on the door. The cabinet is standing in water. I'm about to give up =)

Just to be sure, I wanted to revisit your answer based on the contribution from Gismospapa...

Did you shorten the panel or not?

Because for the 217 cm cabinet, the following applies:

217 cm - 57 cm (lower door) - 60 cm (stove) - 92 cm (upper door) = 8 cm for the panel. (7 cm would probably also work - can be adjusted by the gap measurements).

I'm just asking to be sure, because if the panel wasn't shortened, the gap measurements obviously can't fit.