Thermal balancing - Initial values taken for adjustment

2020-12-03 20:01:58

Hm, we have never noticed anything negative regarding the temperatures. Everything was identical in the previous apartment. : I took the measurements at the same time of day at the same spot with different thermometers (switching the thermometers). I can’t get it any more precise. Of course, I can increase the flow now. But I want to set the heating optimally. Does it make sense to change other parameters then? : Don’t tell me you also have more than 20 degrees in the bedroom. Holy crap

No, the bedroom window is always tilted and even colder than at your place. Otherwise, however, on average between 3 and 5 degrees warmer. Sorry.

2020-12-03 20:05:24

You hardly get more than 2-3 K temperature difference (if at all) anyway if it is a well-insulated new building, otherwise you start shifting the heat internally back and forth. The temperatures are similarly low with us, but that is also because I have deliberately had the whole place designed for only 20° room temperature.

2020-12-03 20:13:21

What speaks against turning off the bedroom completely? I have disconnected all ERR anyway.

2020-12-03 20:30:12

I don't know if it's nonsense, but I think I remember reading in the pink HTD forum that you should set a minimal flow rate so that, for example, there are no discolorations/biofilm in the top meters and they become cloudy?

2020-12-03 20:32:07

19 degrees in the bathroom, I would be freezing. Brbrbrbr

2020-12-03 20:55:05

so that, for example, discoloration/biofilm does not form in the top meters and they become cloudy?

There should always be some flow. However, if the top meters become cloudy, it is more likely due to errors in the system and also the low temperatures, etc., rather than the lack of flow.

What speaks against turning the bedroom off completely? I have disconnected all ERRs anyway.

What would be the intention? You don’t save anything by doing that. The comments about probably inaccurate measurements were just a side note. Because usually it is always a curve that swings back and forth a bit.

Similar topics
05.02.2016	What colors for the bedroom?	44
15.02.2015	Dressing Room/Bedroom Problem - Floor Plan Discussion	25
20.02.2015	Is the bedroom on the south side too warm?	18
19.05.2015	Heating children's room, bedroom, and bathroom	14
09.09.2016	Bedroom design	35
07.02.2016	Floor plan of master bathroom and passage to bedroom	13
10.02.2016	Looking for a clever bedroom idea with a walk-in closet	19
22.02.2016	Size of the bedroom and children's room	38
26.04.2016	Warm bedroom in the house with ventilation including heat recovery	24
14.11.2016	Carpet in the bedroom despite underfloor heating?	36
13.10.2016	Extra bathroom from the bedroom or storage room after all?	29
20.04.2017	Circuit - Bedroom - Ceiling Light / Bedside Lamp	12
26.09.2017	Skylight in the bedroom?	13
09.01.2018	Exhaust air in the bedroom - supply air in the storage room	24
10.03.2018	Children's room and bedroom - What size is recommended?	56
09.02.2018	Connection Bedroom / Dressing Room / Bathroom	16
03.11.2018	Moisture in the bedroom on the exterior wall - Where does it come from?	10
14.11.2018	Room thermostat with rotary knob from Busch Jäger	30
09.12.2019	Bathtub in the bedroom - what do you think about that?	35
25.05.2022	Bedroom too warm - despite the heating being off	44

Thermal balancing - Initial values taken for adjustment

seat88

lesmue79

Tx-25

lesmue79

tomtom79

Mycraft