Seal the vapor barrier film tightly: Are there other solutions?

  • Erstellt am 2016-04-16 10:11:40

kanick

2016-04-16 10:11:40
  • #1
hello
I am working on the cavity insulation of my roof. currently I am doing the two side attic rooms. 2x100mm homatherm will be installed under the roof and on top of that a vapor barrier foil. then cross battens with 22mm insulation and then wooden battens.
if I now want to connect the vapor barrier foil on the side, I do this on the straight beams with Orcon-F connection adhesive. but there are also places where this is not so easy, see photo.
on the left is a wooden beam wall made with the bar knitting method (interior wall, will not be insulated, approx. 50mm thick) below there are floorboards about 30mm thick. on the right it is simple, the foil continues easily.

do I simply fill all cavities here (up to 12mm, or in the joints between the wooden beams significantly more) with the cartridge or is there a better solution?

the new wooden frame is by the way simply the lateral end for the wood wool
thanks a lot and best regards, Nick
 
Oben