Mounting rods for wall-mounted toilets not in water - is that normal?

Hello everyone!

We want to do everything ourselves regarding the bathroom parts in front of the wall – now I noticed during a walk-through that these mounting rods on which the wall toilet is slid are not really level:


Also, as far as I know, these cannot be turned back inward with a flathead screwdriver. A Geberit concealed cistern (I believe Sigma) was installed.

Is this normal?

Thanks & regards,
DR

hm... I think so, because: The [SanitärObjekte] have plenty of play to be leveled.

Which Geberit exactly? Can you adjust the height from above? Maybe just misaligned.

How big are the holes in the tile?

Which Geberit exactly? Can you adjust the height from above? Maybe just skewed.

How big are the holes in the tile?

1x Geberit Sigma and once Omega - it's crooked for both.

I can't reach from above anymore, it's already tiled over.

The sanitary objects have plenty of play to set them plumb.

Okay, good to know - it would just be really stupid if it's so crooked that it's not enough ;-)

From above I mean when operating the flush.

By above I mean when operating the flush.

Ah :) I have to check that! Thanks for the tip