Irrigation and mowing robot 900 sqm on a slope

Hello everyone,

the following situation: on our property there is grass infiltrated everywhere with weeds, so I am considering plowing everything and reseeding.
In this context, it would make sense to lay irrigation and boundary wire for the robot at the same time.

I played around a bit with the DVS planner and this is what came out.

Blue are the old hedges and bushes, which can get wet, but do not require independent irrigation.

Does this make sense or is it total nonsense?

At the bottom near the water tap there is a cistern, which I would use to supply.

The slope from bottom of the plan to top of the plan is about 3m.

Regards,
Harv

Lawn mowers on slopes are not without challenges. The tilt sensors often lead to shutdowns if not accounted for with sufficient buffer. This regularly results in having to go up 1-2 classes in size.

Yes, I had already read that too. I would probably be leaning towards the Husqvarna 430X. The tight passage to the left of the plan concerns me more.

Cover the narrow area with strip sprinklers. How narrow are the driveways?

Thank you, I only found it in the app afterwards and planned it there! The dry spot at the top right is not a problem, as a seating area is planned there in the medium term.

The slope to the right of the house is 33 degrees, on the left it is 35 degrees.

The minimum clearance width is 1m, including 16cm mowing edge on each side