AndreasK64
2015-09-22 08:49:54
- #1
Hello everyone,
Yesterday, I unfortunately had to find out that a measurement in the assembly instructions is incorrect, at least for my oven unit. According to the instructions AA-1514906-1/Page 13, a dimension of 167mm must be maintained from the bottom of the casing to the underside of the rail. Unfortunately, this was 2mm too high, causing the oven to hit the upper rail. After pulling out the oven, I checked this again with a set square and measuring tape: I definitely maintained 167mm. Since I had already set the countersunk fixing screws, I replaced them with pan head screws so that the rail now rests on the screw. The resulting 165mm fit then. Therefore, be sure to check before setting the fixing screws (Page 14 upper picture) whether the oven fits. There are probably manufacturing variations in the oven housing or it is generally an error in the instructions.
Regards,
Andreas
Yesterday, I unfortunately had to find out that a measurement in the assembly instructions is incorrect, at least for my oven unit. According to the instructions AA-1514906-1/Page 13, a dimension of 167mm must be maintained from the bottom of the casing to the underside of the rail. Unfortunately, this was 2mm too high, causing the oven to hit the upper rail. After pulling out the oven, I checked this again with a set square and measuring tape: I definitely maintained 167mm. Since I had already set the countersunk fixing screws, I replaced them with pan head screws so that the rail now rests on the screw. The resulting 165mm fit then. Therefore, be sure to check before setting the fixing screws (Page 14 upper picture) whether the oven fits. There are probably manufacturing variations in the oven housing or it is generally an error in the instructions.
Regards,
Andreas