Ikea PAX wardrobe with sliding doors, top rail does not fit...

Hello, the top rail, into which the sliding doors are hung, is not flush after I clipped it into the plastic holders, so I cannot fold it 90° around the edge of the cabinet. Has anyone ever had this problem? And the solution for it?
Regards

Hi, could it be that you did not maintain the distance of 60 mm? Because of that, the drill holes are too far back and the rail cannot point downwards. Actually, you just have to slide the rail in and not turn it downwards. Regards Maverick1854

I have exactly the same problem! Thank you Mav, that would be a possible source of error, but I have the version where the holes are already there. You really have to bend the rail quite a bit, and even then it still doesn't lie flat on the side walls. Or is it supposed to be like that?

I just spoke with an Ikea employee who said that you should actually be able to just click it in at the top so that the rail lies flat both on top and at the front... weird

That is why appropriate clips are screwed onto the inside of the upper cabinet, which fix the rail at a 90-degree angle

Tip: Only tighten the clips on the top of the cabinet slightly, place the rail, tighten the lower clips firmly, only then tighten the upper clips firmly