cyber
2009-11-20 20:08:12
- #1
Hello everyone,
I have a problem with mounting the handles of the Nyckelby doors, which are attached to the Billy shelf. According to the instructions, the handles are supposed to be simply inserted on one side into the aluminum profile of the door frame and then basically clipped outward over the profile until a small nose on the outer edge of the profile clicks into place. However, the handles are made so tight that I cannot get this nose over the profile edge. I could press harder, but I don't dare because the frame already deforms a lot in the process. A lot of pressure is also applied to the glass pane. Are there known cases where the handles were simply made too tight? Maybe I just have to proceed with a bit more "brutal" force? Who can help?
Regards, Cyber
I have a problem with mounting the handles of the Nyckelby doors, which are attached to the Billy shelf. According to the instructions, the handles are supposed to be simply inserted on one side into the aluminum profile of the door frame and then basically clipped outward over the profile until a small nose on the outer edge of the profile clicks into place. However, the handles are made so tight that I cannot get this nose over the profile edge. I could press harder, but I don't dare because the frame already deforms a lot in the process. A lot of pressure is also applied to the glass pane. Are there known cases where the handles were simply made too tight? Maybe I just have to proceed with a bit more "brutal" force? Who can help?
Regards, Cyber