Ikea Maximera drilling fronts 60cm x 20cm and 60cm x 40cm

Hello,

I have an Ikea Metod cabinet with three Maximera drawers, (2 pieces 60cm x 20cm and 1 piece 60cm x 40cm), for which I am making the drawer fronts myself. Now I am still missing the dimensions for the drill holes in the fronts. I have already searched in the forum and on the internet and have only found this somewhat older entry and am not sure if the measurements are still correct:



Can someone check / confirm this, or measure the holes, or does anyone know the dimensions for the drillings?

Thanks!

Best regards,

Ernest

Question still interesting?

Hello,
Thanks, not really anymore. I then bought fronts and coincidentally drilled more yesterday. I drilled the holes from below at 36, 56, 184, and 204mm and from the side at 35mm. However, this may not be completely (1-2mm deviation) accurate, but the fronts fit. From this, I conclude that the dimensions from the link above are no longer correct.
Best regards, Ernest