Ikea Maximera and Miele Built-in Oven Doors Installation Tips

Hello,

we bought a Metod base cabinet for our Miele built-in oven.
Under the oven, we installed a Maximera drawer.
After everything was finished, we noticed
that when opening the oven, the door comes into contact with the drawer.
It gets worse when closing, then the oven door is pushed upwards.
If I open the drawer a little, it works without any problems.
We installed the rail and drawer correctly. I also adjusted the drawer on the sides to the lowest setting.
Maybe someone can give me a tip. In the worst case, I’ll have to plane it down.
Although I’m not sure if the drawer will still look good afterwards.

Thank you very much

Hello, does the drawer front close flush with the body at the bottom?

No, not quite. There is about a 1/2mm difference. It is not a straight edge.

To avoid misunderstandings, the drawer front therefore almost completely covers the corpus bottom, except for 0.5 mm. If that is the case, could you please upload pictures, overall view, details, closed, open...

The front ends almost flush, it just sticks out about 1-2mm at the bottom. That wouldn’t really bother me. What bothers me is the issue with the oven door. I will take some pictures tomorrow, my shift is calling.