How to clad the WC pre-wall element?

  • Erstellt am 2016-03-29 17:44:04

dettec61

2016-03-29 17:44:04
  • #1
Hello everyone,
I will soon have the task of building a pre-wall toilet, which is to be tiled. Now the question arises, since I am supposed to double-board;
How is it with the depth settings of the supply / wastewater and the manual operation?
With the double boarding, everything sits about 13mm further outwards?
A console from [Fa. Geberit] is to be used.
 

Tubifex

2016-03-29 18:18:35
  • #2
Make it easier for yourself and choose the Geberit Monolith!
 

dettec61

2016-03-29 18:54:26
  • #3
Does not fit in this spot, is in a corner, angled at 45°, and about a wall width of 1.20 meters. At this spot, the monolith does not look as good.
 

Tubifex

2016-03-30 10:46:34
  • #4
No problem with corners either, check out the pages of Grumbach Eck-WC-Stein
there you have what you are looking for!!
 

dettec61

2016-03-30 22:46:27
  • #5
Hello Tubifex, as I already wrote, the width of the corner is about 120cm and then under a sloping roof. And unfortunately, this does not answer the fundamental question of the depth setting of the control elements...
 

Similar topics
19.01.2022How to clean the Geberit wall drain shower in case of clogging?15
11.05.2020How to recognize Keramag / Geberit KeraTect?16
07.06.2022Which wall toilet: Villeroy & Boch, Geberit, Duravit???39

Oben