Bauknecht Dishwasher

Hi ....does anyone have experience with electrical appliances that are not from Ikea? This week we bought a new Metod kitchen and also a new Bauknecht dishwasher. Now the seller says it wouldn't fit. I'm a bit worried .... according to the information sheet, the dishwasher is about 90 cm high .... Best regards Emma08

Hello,
if the device is 86 cm high, then it might work with the Stefan method (see thread dishwasher fronts).
If not,
a) semi-integrated device: try installation with ERSÄTTARE
b) fully integrated device: If the front is usually attached to the door with three screws, install with BEHJÄJLPLIG. For a different attachment, find your own solution for attaching Behjälplig.
c) if possible, exchange for an XXL machine from Siemens / Bosch with Vario hinge.

hello first of all

yes, there are some points that require a bit of imagination and unconventional implementations

Thank you very much for your quick help. It is basically only about the installation height of the dishwasher. We specifically bought one with a stainless steel front to avoid the whole dilemma. Since the brochure stated about 90 cm and the salesperson confused me, I have now researched again and found out that the dishwasher is variably adjustable from 82-90 cm. Therefore, it should now fit after all, since the cabinets have 80 cm and 8 cm feet.
Best regards, emma08

It will then also be a kind of Stefan solution with a piece inserted between the dishwasher and the countertop, as bubbel nicely did (just thicker). At the bottom, the front could remain too short if the minimum plinth height is greater than 8 cm.