Aedel door hangs in front of the extractor hood

Hi!

I just hung the FA336 extractor hood with an Ädel door (300.600.59), and when you install the door hinges Integral 125o (701.323.75), you can't go much "wrong." The holes are there, and with snapping the hinges for the cabinet into the other part (Picture 1 of the instructions), everything should fit reasonably well. I firmly pressed and tightened the screws in the cabinet body.

But now the door is hanging and rubbing against the pull-out extractor hood.

Can someone help me with the adjustment?

Regards, Jan :)

Is the door hanging crooked and only rubbing on the hinge-opposite side, or is it rubbing across the entire width?

p.s.: FA336 is a cabinet, not a range hood. I now assume it is an under-cabinet range hood with the small range hood cabinet above it.

Is the door hanging crooked and only rubbing on the side opposite the hinges, or is it rubbing across the entire width?

... the contact is on the side where the handle is – so on the opposite side from the hinge. Possibly a photo tomorrow.

FA336 is a cabinet, not a range hood. I now assume it is an under-cabinet range hood with the small range hood cabinet above it.

Correct!

Best regards, Jan :)

If you turn the screw closer to the corpus edge at the lower hinge clockwise, at the upper hinge counterclockwise, the door will be aligned properly. Good luck!